|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#8
|
|||
|
|||
|
Re: pic: 334 Shooter Hint
Best thing we did, was get a piece of material you would typically cut/use (ours is 6061 or 5053 1/8" AL) and make a series of small parts making small changes to the heat and speeds as per torches guide. hypertherm does a great job of tabulating all speeds/feeds/amperage ratings. once you're happy with what a flying torch will do at 150ipm you're set!
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|