|
|
|
 Remember; FIRST is staffed by real live humans, some of whom have a sense of humor. - Andy A. [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Remember; FIRST is staffed by real live humans, some of whom have a sense of humor. - Andy A. [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
26-01-2013, 14:07
|
|||
|
|||
|
Re: How to wire solenoid?
The image is a double action solenoid, but it does not show that there are two wires to each side. '-' and 'signal' are marked on the digital breakout, so just follow what it says and wire '-' to black and 'signal' to red on the solenoids. A double action solenoid will require two sets of pins. For ease of connection, you can cut one pin off of a PWM and it fits fine on the breakout.
Last edited by mhall : 26-01-2013 at 14:37. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode