How to display image (RGB, Binary, HSV, etc.) on driver station screen

[Toa Circuit]

If you look at the image processing example... there is the following lines:

BinaryImage *thresholdImage=image->ThresholdHSV(threshold); // get just the green target pixels
//thresholdImage->Write("/threshold.png");
BinaryImage *convexHullImage=thresholdImage->ConvexHull(false); // fill in partial and full rectangles
//convexHullImage->Write("/ConvexHull.png");
BinaryImage *filteredImage=convexHullImage->ParticleFilter(criteria, 1); //Remove small particles
//filteredImage->Write("Filtered.png");

Uncomment the commented out lines and the files will be saved to the cRIO. Just then get them off with FTPing to the cRIO (At 10.xx.yy.2) with a program like FileZilla.
The documentation reccommends you comment out the loop before writing to the cRIO flash though to keep it from deteriorating. How important this is, Im not sure of. I did it though, and it worked just fine for our purposes, if not better (Cause we could just enable and grab processed pictures, then reenable again and such.)

[Greg McKaskle]

The cRIO is sold industrially for machine monitoring. The filesystem does wear-leveling and the flash is capable of many many rewrites. It is fine to use the flash for debugging, that is one of the reasons it is there.

Greg McKaskle