Servo problems

[Ether]

Originally Posted by pigpenguin

yeah we have placed a jumper on the two pins next to the pwm out

Apologies for asking the obvious question, but do you have a center wire in your PWM cable and 3 pins at each end?

[pigpenguin]

Originally Posted by Ether

Apologies for asking the obvious question, but do you have a center wire in your PWM cable and 3 pins at each end?

yes

[Greg McKaskle]

Have you tried using test mode to identify whether it is a code or electrical issue?

Greg McKaskle

[AsianRookie]

servo.set(value), is value between 0 and 1?

[pigpenguin]

Originally Posted by Greg McKaskle

Have you tried using test mode to identify whether it is a code or electrical issue?

Greg McKaskle

No, to be honest I have never heard of test mode. I will try that tomorrow when I get my hands on the bot again.

Originally Posted by AsianRookie

servo.set(value), is value between 0 and 1?

Yes, the way we have it set up right now we have a button, when the button is not pressed the servo is set to 0.0 and when it is pressed the servo gets set to 1.0

[pigpenguin]

For any one curious it was a bad jumper... which was the one thing no one thought to check.