pic: Is this legal?

[Tristan Lall]

Originally Posted by CalTran

Link to the question and response please?

Wrapping is described in the bottom figure of update 2013-01-15, and mentioned in Q137.

Note that this business about the corner protection wrapping around other corners is new for this year.

[MrForbes]

That does not make sense.

Oh well.....

[FrankJ]

Originally Posted by MrForbes

That does not make sense.

Oh well.....

I think the rules committee made a creative interpretation to allow a frame side to be less than 8". The rules committee does not have to make sense. To quote Lily Tomlin "They are omnipotent" Now tell me where that quote came from.

In terms is the pic legal? Only your inspector will know for sure. But you bumper will have to comply with R29 & wrap around the 1" fillet so that is is fully supported.

R29

BUMPERS must be supported by the structure/frame of the ROBOT (see Figure 4-6). To be considered supported:

A. a minimum of 1 in. at each end of the BUMPER must be backed by the FRAME PERIMETER,
B. the gap between the backing material and the frame must not be greater than ¼ in., and
B. no section of BUMPER greater than 8 in. may be unsupported.

[neshera]

If you have a Q for Q&A, make sure you reach the party to whom you are speaking <snort>.

[GaryVoshol]

I've been thinking about this. That 1.414" section of Frame Perimeter would have to have its own section of bumper - complete with plywood, noodles, fasteners. Pay attention to R29A.