|
|
|
 I sincerely hope no one on CD is going to neg rep you for thinking - Richard Wallace [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I sincerely hope no one on CD is going to neg rep you for thinking - Richard Wallace [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
29-01-2013, 08:39
|
|||||
|
|||||
|
Re: Redeploying Code without reimaging the cRIO
We had a problem several years ago where the code we had on the cRIO was using up 100% of the processing power, so we had to boot it into no code to load the new code onto it. It sounds like you could be having the same problem. Try toggling the "No Code" dip switch on and restart the cRIO, then load your code and toggle the dip switch back off, restart and you should have new code.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode