|
|
|
 As for Dave and the stairs, just ignore him like the rest of the FRC GDC does... ;) - Rich Kressly [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| As for Dave and the stairs, just ignore him like the rest of the FRC GDC does... ;) - Rich Kressly [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
29-01-2013, 20:46
|
|||
|
|||
|
Re: Bearings Falling off
A few of the wheels we got the bearings dropped right into place, no press or deadblow and block needed, same with the plastic pulley halves. With spacers in place its not a big deal. just had to make sure none of them slipped out while putting them on the chassis and then have to undo the bolt and the spacers and start again.
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode