|
|
|
 FIRST continues their full-frontal assault on mentor's vacation days. - Lil' Lavery [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| FIRST continues their full-frontal assault on mentor's vacation days. - Lil' Lavery [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
30-01-2013, 21:26
|
||||
|
||||
|
Re: CIM Motor Burn Out Question
Depends on what type of pneumatic wheel you have. If they are these http://www.andymark.com/product-p/am-0970.htm you could attach couple of shaft bearings on it, throw a shaft on it, then attach a sprocket on the mounting holes on the wheel.
I'm a programmer so sorry if I'm not too much help... |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode