sprockets - Chief Delphi

21-01-2003, 18:51

hi_im_sean hi_im_sean is offline

Registered User

#1223

Join Date: Jan 2003

Location: mesa, az

Posts: 16

hi_im_sean is an unknown quantity at this point

assuming you are talking about drive gears
i dont think steel is much of a problem as long as its not to big, aluminum would be the best , but i would never use plastic. it will break or strip out way to easily.if your budget allows it i would use the aluminum gears , evn though they are more expensive.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
need help fast!!! Hubless 1/4 pitch sprockets	Travis Covington	General Forum	6	03-02-2003 18:44
modifying sprockets	gail	OCCRA	3	05-10-2002 12:13
Chief Delphi sprockets	archiver	2001	23	24-06-2002 01:46
Re: Connecting hub sprockets to shafts	archiver	2001	1	24-06-2002 00:20
Attaching the Gears and sprockets to the shaft	archiver	2001	2	23-06-2002 23:18

All times are GMT -5. The time now is 18:45.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.