|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
|
||||
|
||||
|
Re: pic: 2386 chassis mock-up 2
Its 3/16; and it was supplied stock from a generous sponsor. We might be able to go 1/8th. We've gone thicker and it was unnecessary, but we feel any thinner will be an unnecessary compromise with not a noticeable weight difference. Besides, we can cut larger lightening holes out with 3/16 than we would with a thinner gauge to offset the difference in weight. Good question.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|