|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||||
|
|||||
|
pic: T3's New Tool: The Mathe Lill!
|
|
#2
|
||||
|
||||
|
Re: pic: T3's New Tool: The Mathe Lill!
Or 4th axis
![]() |
|
#3
|
|||||
|
|||||
|
Re: pic: T3's New Tool: The Mathe Lill!
Currently it looks like a mill with a rotary indexing table on it, actually. You guys hobbing custom gears or something?
My lack of confusion is likely because I've actually setup and programmed a custom CNC machine tool that's an actual mill/lathe combo. It's a lathe with a fairly slow rotating chuck and a high speed rotary spindle where the tool holder would normally be. So milling round parts instead of cutting them with stationary tools. |
|
#4
|
|||||
|
|||||
|
Re: pic: T3's New Tool: The Mathe Lill!
Unsure if you guys are just playing around or not, but we actually did this today w/ a CNC 4th (on a manual mill).
We rough turned some shafts, and cut gear teeth onto them as well. It was a fun day for the champion who made these guys. |
|
#5
|
|||
|
|||
|
Re: pic: T3's New Tool: The Mathe Lill!
My team has a set up like that we use it for making gears. Does your team do the same?
|
|
#6
|
||||
|
||||
|
Re: pic: T3's New Tool: The Mathe Lill!
AKA: A Dividing Head
|
|
#7
|
|||||
|
|||||
|
Re: pic: T3's New Tool: The Mathe Lill!
You can also get a lathe with a mill...
http://www.youtube.com/watch?v=46aHPR4MQjk What you have is just a Mill. :-) |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|