|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||||
|
|||||
|
Cypress PSoC 3 driver problems
We plan on using our control board from last year. I have installed everything that comes on the CD for the PSoC 3 board, and I have installed the PSoC programmer 3.17 right from Cypress's website. When I open up device manager, I get an Unknown Device message.
I am currently running this on Windows 8, so that may be the problem. If anyone has any idea of how to get Windows to recognize the board so that I can set up the Configuration in the Driver Station and start programming this thing in LabView, thank you. I'll provide any information as needed. -Landon, Team Fusion 364 Programming |
|
#2
|
||||||
|
||||||
|
Re: Cypress PSoC 3 driver problems
You probably have the wrong version. See http://wpilib.screenstepslive.com/s/...module-for-frc
|
|
#3
|
|||||
|
|||||
|
Re: Cypress PSoC 3 driver problems
I have been successful with the board on other computers that were configured correctly. I also programmed it to do certain fuctions with a proto bot.
I'm sure that the firmware is loaded correctly and that this is most likely a computer issue. Edit: I have gotten the drivers installed. I will upload firmware asap just to make sure that it is up to date. Now that I have gotten the drivers installed on our laptop, I tried testing the board in the driver station. It isn't working. I went to the old computer that it worked on and it isn't working on that one now. I'll see tomorrow what i can get working. Last edited by Landonh12 : 04-02-2013 at 21:01. |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|