pic: 3992 Drive Train

[ksafin]

Originally Posted by akoscielski3

it would attempt to strafe, and would kinda move, but not really.
There was not enough reduction, usually people would use toughboxes on macanum's we were dumb and didn't
did you have 150lbs on that robot? that's when you need to the torque.

What about putting a Mini-CIM in each gearbox for additional torque? Or RS-775's on CIM-U-Lators?

[Gregor]

Originally Posted by ksafin

What about putting a Mini-CIM in each gearbox for additional torque? Or RS-775's on CIM-U-Lators?

Thats not a bad idea, and probably the fastest switch, but switching to Toughbox Mini's would give you the best results.

[ksafin]

Originally Posted by Gregor

Thats not a bad idea, and probably the fastest switch, but switching to Toughbox Mini's would give you the best results.

We'll see what we can do.

We'll test with this and a heavy load on the chassis and see if the results are poor enough to warrant the switch.

If anything, I think we'll switch to toughbox Nanos. The mini has a front plate bigger than our actual plate so it'd be an odd fit.

[Gregor]

Originally Posted by ksafin

We'll see what we can do.

We'll test with this and a heavy load on the chassis and see if the results are poor enough to warrant the switch.

If anything, I think we'll switch to toughbox Nanos. The mini has a front plate bigger than our actual plate so it'd be an odd fit.

TB Nanos are also a good choice, I like them.