PWM Channels Not Responding?

Putting 2 and 2 together, and then mixing them back up for someone else to try and get 4 in a different way is just plain fun. - Elgin Clock [more]

		Chief Delphi > FIRST > General Forum
PWM Channels Not Responding?

Thread Tools

Rate Thread

Display Modes

08-02-2013, 19:22

Team 4457

Registered User

FRC #4457

Join Date: Jan 2013

Location: Portland Or.

Posts: 16

Team 4457 is an unknown quantity at this point

PWM Channels Not Responding?

Hey, so here is our problem:

We are using two talons to run a four motor drive train (we are sure that that is not the problem) and we are correctly wired and all the wires work. But when we go to run the robot, only one of the two PWM channels work (this was determined by swapping around cables). The joysticks both work. Does this mean that this is a programing issue? If so, do you have any idea what is could be?

Thank you,
Team 4457

__________________
~There are always choices, some are just harder to make than others.~

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 10:48.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.