No cRIO communication

[Mark McLeod]

The cRIO has an image if the status light stays out (it blinks if there's an image problem).

I forgot to mention that Netconsole had to have been checked in the cRIO Imaging Tool to get it onto the cRIO, but if the Imaging Tool can't find the cRIO anyway then it doesn't matter.

I'd check your Network interfaces. Do the standard turn off all but the one you're using for the cRIO. Check that one for extra IP addresses under Advanced (on the same window were you see the IP address). Firewalls are off and all that.

[Itamar]

Turning off the firewall did the trick, thank you very much!!!