|
|
|
 Meanwhile, it's water over the dam, spilled milk, etc. Let's drop the subject and get on with life. I am seeing people warming up their lawyerism, which is not a good thing when we are coming up on build season. - EricH [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
Trouble deploying Program to cRIO with NetBeans
I finished programming and ready to deploy my program for a week now. However I cannot get pass where it says "Welcome To LabView Real-Time" and "FPGD software guild .....". Then Netbeans just continue to run without an end, and robot doesn't move.
On another note, how do I get the D-Link to work as an Access Point? 
|
|
#2
09-02-2013, 19:29
|
|||
|
|||
|
Re: Trouble deploying Program to cRIO with NetBeans
Here's an article that describes the download process and what you should see for each step. This might help figure out what's going on in your case.
http://Wpilib.screenstepslive.com/s/3120/m/7885/l/97458 Brad
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
