How to program a limit switch?

[BPtigers]

Right now my motor doesn't even move up or down. The jaguar light is a solid green when the code is enabled, but when I click and hold the up button or down button and push forward the throttle the green light doesn't change at all it appears like the motor is at 0 constantly, so I don't know if the pwn is bad or not or how can I tell just by looking at it? My big question is assuming the code is right, it has to be the wiring, and assuming that the jaguar is wired right it has to be the limit switch wiring. My coach says that if we leave the limit switches unhooked altogether the limit should be false by default, because there is no limit switch plugged in. Is that true when a limit switch isn't plugged in it's naturally false in the code, or since the limit switch isn't plugged in the labview reads it as true, because my motor isn't moving and the only reason I see is since the limit switch isn't plugged in it's screwing it up? Also how is a limit switch suppose to be hooked in if we want it normally open. Thanks for all the help or if you do see an error in my coding let me know thanks. picture with the limit switches doesn't work, but the picture without the limit switches in it works just fine so I don't know where the problem is if it's in the coding.