LabVIEW coding error: Unable to run the robot.

[Tom Line]

Before you do anything with the code, turn the robot on and open the driver station.

What are the driver station diagnostic lights telling you? Does the lower left say "no code", "teleoperated disabled" or something else?

Have you put in your team number in the setup tab?

[anthonyR]

Originally Posted by Tom Line

Before you do anything with the code, turn the robot on and open the driver station.

What are the driver station diagnostic lights telling you? Does the lower left say "no code", "teleoperated disabled" or something else?

Have you put in your team number in the setup tab?

It says no code as I have re-imaged the cRIO and erased all previous code. It also says teleoperated disabled unless I run it. Also the basics for the code are correct. It says 10.16.61.2 for the cRIO and all the communications are in check it just will not run.