|
|
|
 ...if you say "AndyMark" three times we show up... - Billfred [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| ...if you say "AndyMark" three times we show up... - Billfred [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Missing Axis M1011 Camera power Jack
My team has lost the power jack to supply power for the camera. I was wondering if anyone could give information on the size of the power jack, somewhere to buy it and have it shipped within a week (before build season ends.) Any information or advice would be very helpful.
|
|
#2
10-02-2013, 09:57
|
|||
|
|||
|
Re: Missing Axis M1011 Camera power Jack
From another post I came across when I was searching earlier this season:
http://www.radioshack.com/product/in...ductId=2102487 Or this one: http://www.digikey.com/scripts/DkSea...rds=cp-2193-nd Last edited by dsherw00d : 10-02-2013 at 10:00. |
|
#3
10-02-2013, 17:35
|
|||||
|
|||||
|
Re: Missing Axis M1011 Camera power Jack
Size H: 1.35 mm ID, 3.5 mm OD.
|
|
#4
10-02-2013, 19:31
|
||||
|
||||
|
Re: Missing Axis M1011 Camera power Jack
Ours disappeared mysteriously and finally we gave up looking for it. Got a replacement from the local Radio Shack(see link in previous post for the correct part size), wired it up and it has been working fine since. The back of the camera gives a schematic for polarity so be sure to double check that before the final hook up.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
