CRIO Image tool won't recognize pneumatic breakout

[Joe Ross]

Yes, it should be slot 3. If you look at the cRIO slot 3 pins, do you see any damage? A bent pin would cause the module to not be detected.

[RyanN]

Originally Posted by Joe Ross

Yes, it should be slot 3. If you look at the cRIO slot 3 pins, do you see any damage? A bent pin would cause the module to not be detected.

+1 on the bent pin.

We had an issue last year and it recognized that something was there, but it wasn't sure and it caused all sorts of little problems. We found a single bent pin, which I repaired myself. Works great now.

Of course, if you aren't comfortable trying to bend the pin back by yourself, maybe find someone else who is or send it to NI to get fixed. It's kind of expensive if you make the problem worse.