Unable to Get CRIO to Work

drill holes, that should fix it - E. The Kidd [more]

		Chief Delphi > Technical > Technical Discussion
Unable to Get CRIO to Work

Thread Tools

Rate Thread

Display Modes

13-02-2013, 15:46

celticsfan645 celticsfan645 is offline

Registered User

FRC #1474

Join Date: Jan 2013

Location: Massachusetts

Posts: 8

celticsfan645 is an unknown quantity at this point

Re: Unable to Get CRIO to Work

Ok everyone, I managed to get the CRIO to work. What I did was I turned the IP Reset button on, rebooted the CRIO, turned the IP reset button off again, rebooted again, and then used the NI MAX to set an IP address. After that, I just had to re-image the CRIO. Thanks to all of you for your help.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 00:20.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.