|
|
|
 [Programming a swerve drive] It's really really simple, unless you actually do it. - Ether [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| [Programming a swerve drive] It's really really simple, unless you actually do it. - Ether [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#2
14-02-2013, 09:25
|
||||
|
||||
|
Re: cRIO Imaging Problem
Do you have the modules powered? Such as through the breakouts and the sidecar?
|
|
#3
14-02-2013, 10:02
|
||||
|
||||
|
Re: cRIO Imaging Problem
You might want to try plugging in a serial cable and getting the boot up information. This will tell you weither or not it is actually rebooting, or if it is failing to do such. this should also display any errors you get.
|
|
#4
14-02-2013, 10:55
|
||||
|
||||
|
Re: cRIO Imaging Problem
Attach a router or the new bridge between the cRIO and the computer. Sometimes the reformat will temporarily disconnect the computer and cRIO, and as a result some computers don't like it.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
