|
|
|
 Mostly, however, I find that once the students start building a robotics project, they are too busy learning for me to teach. - dtengineering [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Mostly, however, I find that once the students start building a robotics project, they are too busy learning for me to teach. - dtengineering [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
cRIO Imaging Error
I am currently trying to image my teams cRIO using the imaging tool but an error appears every time saying- "cannot assign IP adress- make sure that the reset ip switch is off". The switch is off, my computers ip is set correctly. I heard that you are supposed to do this using a crossover cable (I was using ethernet) so I tried to use a wireless bridge- same error. Any ideas?
|
|
#2
13-02-2013, 23:04
|
||||
|
||||
|
Re: cRIO Imaging Error
It's not recommended to image over wifi. I believe you should just use ethernet and not a crossover. Double check the documentation at the link below for correct IP settings. There is a virtual switch for IP reset for 4 slot or a physical switch for 8 slot cRio.
http://wpilib.screenstepslive.com/s/...ging-your-crio
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Linear Mode
