pic: 1515 Teaser

[msimon785]

loading photo ...

[Rob3653]

10 point climber!

[Gregor]

Wedge to lower the bridge?

[DampRobot]

Originally Posted by Gregor

Wedge to lower the bridge?

Definitely a minibot deployment alignment guide.

[theawesome1730]

What did you use to do the fillets like that? Is bead/sand blasted?

[Akash Rastogi]

Originally Posted by theawesome1730

What did you use to do the fillets like that? Is bead/sand blasted?

The edges may just look like that because it was jetted. The surface looks like it was sent through a Time-saver though.

[Andrew Schreiber]

Originally Posted by DampRobot

Definitely a minibot deployment alignment guide.

Grabber for the mobile goals?

[Botwoon]

Is it okay for me to guess if I've already seen the part name?

[Whippet]

Originally Posted by Andrew Schreiber

Grabber for the mobile goals?

Obviously part of a trailer hitch.

[Andrew Schreiber]

wrong year

[Gregor]

Originally Posted by Andrew Schreiber

wrong year

But the question is, who are you talking to? We can't all be wrong.

[Andrew Schreiber]

Originally Posted by Gregor

But the question is, who are you talking to? We can't all be wrong.

I think all of us being wrong was the point of the exercise.

[SenorZ]

Well, if that isn't a triangle, then perspective tells me its WAY too long to fit in starting configuration.

I'm guessing its a truss for a small bridge that you're putting on your robot for Frisbees to safely cross into a goal.

[theawesome1730]

Originally Posted by Akash Rastogi

The edges may just look like that because it was jetted. The surface looks like it was sent through a Time-saver though.

We water jet a lot of part but the edges don't end up looking like that. The are typically very rough and square.

[msimon785]

Those edges are actually from right off the waterjet. The finish is after a light application of a wire brush wheel. The apparent fillet is actually not a fillet; merely a discoloration. The edges are quite sharp. This happens on all our waterjet parts.