Single Motor Teleop/Autonomous being quirky.

[Tom Line]

It causes no end of problems in LabView when people use multiple set motor outputs in different locations.

My suggestion is to have your set motor outputs in Autonomous and Teleop, because you know they never operate concurrently. Have a global variable set the output. Then, set the value of that global variable in the periodic task loop.

Likewise, never set a global variable in more than one place at one time. You can set them in teleop and in auton. Or you can set them in periodic tasks. But you should not set them in teleop AND periodic, and you should never set them in auton AND periodic. You will inevitably run into race conditions if you set a global in 2 vi's that are running at the same time.