Using Anderson PowerPoles

Failure is in my eyes, the key to success. If you can deal with failure, look it in the eye, and conquer it, the hard stuff won't really intimidate you any more...and you can only get better. - Andy Grady [more]

		Chief Delphi > Technical > Electrical
Using Anderson PowerPoles

Thread Tools

Rate Thread

Display Modes

#16

15-02-2013, 07:35

Al Skierkiewicz Al Skierkiewicz is offline

Broadcast Eng/Chief Robot Inspector

AKA: Big Al WFFA 2005

FRC #0111 (WildStang)

Team Role: Engineer

Join Date: Jun 2001

Rookie Year: 1996

Location: Wheeling, IL

Posts: 10,798

Al Skierkiewicz has a reputation beyond repute

Re: Using Anderson PowerPoles

Either the terminal is upside down, you are using the small section or there is a problem with the crimper. The terminal should insert into the tool in the center port (if you are using the 35 amp contacts) with the contact area up. Can you post a picture of the contact after you crimp?

__________________
Good Luck All. Learn something new, everyday!
Al
WB9UVJ
www.wildstang.org
________________________
Storming the Tower since 1996.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 00:11.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.