|
|
|
 Little kids playing soccer....or a typical Lunacy match. Ah, memories. :cool: - Travis Hoffman [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Little kids playing soccer....or a typical Lunacy match. Ah, memories. :cool: - Travis Hoffman [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Servo not responding
So our robot has a servo that we are trying to get working. Its hooked up to the PWM outputs on the digital side car next to our motors. No matter what we do it wont respond. Its not even powered! In labview I have it using the set angle function. Am I doing somthing wrong? such as when initalising the servo do I need to input the angle variable? Am I using the wrong function? is it pluged in wrong? When I use the same PWM port on a motor it works fine. Any ideas?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode