|
|
|
 I once heard someone say that Dean is "building an army of engineers." I disagree. I think he is building an army of the informed. - Gope [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I once heard someone say that Dean is "building an army of engineers." I disagree. I think he is building an army of the informed. - Gope [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
Warning bad vex pro sipke
While temporarily disconnecting our compressor our team pulled the breaker from the spike controlling it and noticed that the compressor was still running.
after taking it apart we noticed that the two pins in the middle of the fuse holder were soldered together. http://www.granitecitygearheads.com/...2013-Spike.jpg The spike functioned normally ,but does any one know if the two pins in the top left by d6 were supposed to be soldered together? Thanks FRC #3244 sorry about the image size i haven't posted much Last edited by artdutra04 : 17-02-2013 at 04:34. Reason: Replaced huge embedded image with link. Please do not embed images in posts that are over 1000ish pixels wide. Thanks. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode