servo problem

[akash992391]

can some one tell me, do i have to put 0 to 180 on servo angle or 0 to -1
i try everything to programmed function and everything but still not working can someone help me.....

[Garten Haeska]

0 to 180 and make sure you have a jumper on the two pin connector next to the pmw of your choice.

[akash992391]

i tried 0 to 180 still doesent work

[Garten Haeska]

Do you have a jumper installed?

[akash992391]

yeah i did

[Garten Haeska]

Your code should look something like this.

[akash992391]

yes i do have same one...

[Garten Haeska]

Could you post your code?

[Ether]

Originally Posted by akash992391

i tried 0 to 180 still doesent work

You aren't trying to lift a 10 pound weight with that servo, are you ?

[akash992391]

no i m not lifting anything

[Ether]

Originally Posted by akash992391

no i m not lifting anything

Do you have a cheap digital voltmeter handy?

[Mark McLeod]

Does putting the Driver Station into Test Mode, and using the Dashboard Test tab, let you move the servo?

[akash992391]

here is a code

[akash992391]

yeah i do y

[Garten Haeska]

right now your two positions are using double numeric values when i believe they should be just numeric values. (Changes the orange numbers to blue numbers)