Volts in Driver Station reads 00.00

[Mark McLeod]

Code and settings have nothing to do with it. It's a service that's provided by the FRC system.

Have you wired 12v power from the Power Distribution Panel directly to the Analog Breakout?
Is the Breakout longer than the similar Solenoid Breakout?

[jojoguy10]

Originally Posted by Mark McLeod

Have you wired 12v power from the Power Distribution Panel directly to the Analog Sidecar?

Do you mean the blue module or the breakout board? We have the 12V to the breakout board (white connector) if that's what you mean...

[Mark McLeod]

I'm not sure what you mean by blue module, but it might be the Power Distribution Panel (the one with all the circuit breakers).
You guessed right about my meaning though, the Analog Breakout is receiving 12v if the green status light on it is glowing green.

The only pieces that affect the voltage display on the Driver Station are mostly the electrical wiring and connections:

• The connector in the bottom of the first slot on the cRIO (no bent/broken pins)
• The Analog module installed in the first cRIO slot (no green LEDs on it like the Solenoid cRIO Module)
• The Analog Breakout
• The jumper on the outer two pins of the Analog Breakout
• The 12v power wired via a white wago to the Power Distribution (green status on the Analog Breakout)
• A circuit breaker for the circuit on the Power Distribution Panel

• In code if you opened Analog 8 (Analog 8 should be left alone)

[jojoguy10]

Thanks! I'll check with our electrical team about these and get back tomorrow evening when we check it.

[jojoguy10]

OK, so we fixed the problem. Apparently, the electrical team crossed the wires. Thanks for the help!