|
|
|
 At first blush, people don't need to know about GP any more than they need to know gear ratios, screw classifications, or LabVIEW. It's about Inspiration. It's about Recognition. It's about Science and Technology. That's all it's For; any more than that is just gravy. - Taylor [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: LabVIEW Not Writing Numbers to SD
Also read the comments on the diagram, the large green boxes. If you place the slider in the Operation tab, like the Slider 1, and name it with your variable, you are done. The writes are done for you.
If you want more control or more interaction, you do need to consider when the code is run, and typically you want it in a loop. Greg McKaskle 
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
