Gyro angle will not work with robot code

[Ether]

Originally Posted by AquaMorph

It is to the forth decimal place and moving the gyro doesn't do anything.

Post a photo of how you have it wired. Show both the gyro end and the other end of the cable. Please use the macro setting on your camera for close-ups.

[AquaMorph]

Originally Posted by Ether

Post a photo of how you have it wired. Show both the gyro end and the other end of the cable. Please use the macro setting on your camera for close-ups.

I can't take a picture of it until tonight. However, I know the wiring is correct because I loaded the sample code on the robot and it ran fine and gave me the angles I wanted.

[Ether]

Originally Posted by AquaMorph

I can't take a picture of it until tonight. However, I know the wiring is correct because I loaded the sample code on the robot and it ran fine and gave me the angles I wanted.

We should have asked you right at the start what was your intended use for the gyro.

I just saw on another thread that you are intending to use the gyro for your shooter altitude angle.

I think you want a potentiometer or encoder instead.

[AquaMorph]

Originally Posted by Ether

We should have asked you right at the start what was your intended use for the gyro.

I just saw on another thread that you are intending to use the gyro for your shooter altitude angle.

I think you want a potentiometer or encoder instead.

I think an encoder would work best. I don't think a potentiometer came in the KOP. Do you have an idea of what would be best for a shooter that is going to only moving up and down in a range of 70 degrees?

[Ether]

Originally Posted by AquaMorph

I think an encoder would work best. I don't think a potentiometer came in the KOP. Do you have an idea of what would be best for a shooter that is going to only moving up and down in a range of 70 degrees?

That's a great application for a potentiometer. An encoder would also work.

[AquaMorph]

Originally Posted by Ether

That's a great application for a potentiometer. An encoder would also work.

I don't think I have potentiometer but I can play with an encoder.

[Doc Wu]

Originally Posted by AquaMorph

I don't think I have potentiometer but I can play with an encoder.

You must have a Radio Shack or Fry's somewhere near you. Get a 5K or 10K Linear Taper Potentiometer. They're cheap and easy to wire up and get working.

[mswalker]

We have seen the constantly increasing gyro behavior which seems to be due to bad connections. Check that the connection to the analog board and the gyro itself are solid and don't have any wire "hairs" shorting. Also, as mentioned, check the datasheet for the gain. Our gyro (I think this year or last year KOP) has a gain of 0.007 instead of the 0.0125 of the examples.

[tr6scott]

http://www.chiefdelphi.com/forums/sh...42#post1239642

Please see this post, and see if this explains the issue.