VEX Motor controller? - Chief Delphi

"Imagination is more important than knowledge. Knowledge is limited. Imagination encircles the world." - Albert Einstein - Edward Debler [more]

		Chief Delphi > Technical > Programming > NI LabVIEW
VEX Motor controller?

Thread Tools

Rate Thread

Display Modes

19-02-2013, 12:55

Team 3763 Peter Team 3763 Peter is offline

Registered User

FRC #3763

Join Date: Feb 2013

Location: 4-H Jacksonville, NC

Posts: 2

Team 3763 Peter is an unknown quantity at this point

Re: VEX Motor controller?

Somewhere within the past 4 years, we've probably misplaced those cables. If we clipped the pins from the male connector, and shaped the remaining bit to resemble the female connector, is there any chance that our creation would work? In our Labview code, we have the VEX programmed as a single motor Victor, and it's using a button on our joystick to operate. Is there anything potentially missing in code?

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 12:07.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.