Gear reduction question

24-01-2003, 18:12

dmellich

Registered User

AKA: Mr. E

FRC #1251 (TechTiger Robotics)

Team Role: Mentor

Join Date: Dec 2002

Rookie Year: 2000

Location: Coconut Creek, FL

Posts: 79

Gear reduction question

If two gears/pulleys, different sizes say 60 teeth and 20 teeth are sitting on the same shaft next to each other, is there a reduction factor between them? If so, how is that factor used with other reductions being used? Are they multiplied or added? Thanks for any help.
David M. Ellich

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
gearing design calculation question	caffel	Motors	4	24-03-2003 17:34
Thunder Chicken CCT	Simon G	Motors	4	03-01-2003 13:18
"Motors and Drive train edition" of Fresh From the Forum	Ken Leung	CD Forum Support	6	29-01-2002 12:32
Drivetrain help	thedillybar	Technical Discussion	9	08-01-2002 21:54
Drivetrain Help	Jordan	Technical Discussion	16	02-12-2001 12:14

All times are GMT -5. The time now is 10:39.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.