Solution to Timing Loops

[Steven Carmain]

I have found out how to time. Based of the information from Innovation First, a loop is every 26.2 ms, assuming your code does't lengthen it. Based off of that, there are 38.167938931297709923664122137405 loops per sec. So to do close timing without overloading the stamp, you do:

Time VAR byte
RealTime VAR byte

Time = Time + delta_t + 1
if Time > 38 then
Time = Time - 38
RealTime = RealTime + 1
EndIf

This way only uses 2 bytes insted of a byte and a word. I tryed the delta_t * 262 / 10 but it overloaded the stamp and was very inaccurate.

Based of of this formula, then the basic stamp will be 0.530431579 seconds fast at end of match.

You can check this information on this xls I inclosed.