|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||||
|
|||||
|
Re: Anyone else do an unplanned dismount?
190 had a unplanned dismount during a qualification match. They used steel cable in their arm, and when they started up on the 30 point bar one match, the cable split and the hook went flying and the rest of the robot dropped straight down and went thud.
|
|
#2
|
||||
|
||||
|
Re: Anyone else do an unplanned dismount?
We had a dismount from the first bar in out match. They didn't get lined up quite right, so when we started to lift the hook just slipped off. The hook got bent, but we bent it back and reenforced it.
|
|
#3
|
||||
|
||||
|
Re: Anyone else do an unplanned dismount?
Quote:
. The steel cable snapped while we were hanging from the third rung. This caused the arm (we call it the OSHA, Omni-Sloth Hook Arm) to unwind down until the arm reached its lower limit. The bracket that holds the hook onto the top of the OSHA is designed to be frangible in just such a case to avoid placing undue load onto any of the more sensitive parts of the climber. When it snapped, it shot the hook up into the air and caused us to fall down straight onto our wheels a good five feet or so. After a checkup and quick fix in the pit, everything was back to normal within an hour. |
|
#4
|
||||
|
||||
|
Re: Anyone else do an unplanned dismount?
Quote:
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|