|
|
|
 How many programmers does it take to change a light bulb?
None. They'll just say it's a hardware problem. - crafty [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| How many programmers does it take to change a light bulb?
None. They'll just say it's a hardware problem. - crafty [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
11-03-2013, 22:11
|
|||||
|
|||||
|
Re: 4 cim motor programming in labview
The "proper" way is to replace the Open 2 Motor Drive with Open 4 Motor Drive in the Begin vi.
The easy way is to leave all the programming the way it is and use PWM Y-cables to control two speed controllers from each of the left and right drive motor PWM outputs. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode