3D Printer Advice - Chief Delphi

Place a corner of it on the end of a table, clamp down the other side, and have a good whack at it with a hammer (hard). If it didn't break, it was polycarbonate. - vivek16 [more]

		Chief Delphi > FIRST > General Forum
3D Printer Advice

Thread Tools

Rate Thread

Display Modes

25-03-2013, 11:46

GMAdan

Team member turned mentor

AKA: Daniel A. Cobar

FRC #1881 (GAMMA Elite)

Team Role: Mentor

Join Date: Dec 2006

Rookie Year: 2006

Location: Paterson, NJ

Posts: 110

Re: 3D Printer Advice

I agree with the comments above. It is difficult to get commercial quality for under 10k. I worked with many commercial machines and even with them it takes a good amount of time to dial in the settings. I have spent the take with makerbots and got results comprable to 20k machine I worked with at my university, of course not the same. I don't know the current machine you have currently but maybe thats something to keep in mind.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 02:56.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.