|
|
|
 Ahh yes, the good old "let's dedicate all our resources to absolutely cheesing the opponent alliance" strategy - Jaci [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Ahh yes, the good old "let's dedicate all our resources to absolutely cheesing the opponent alliance" strategy - Jaci [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: Programming Axis Camera 206
No code needed, but I believe the camera settings are a bit different for the two dashboard choices. The LV one allows parameters to be set, so it attempts to use an FRC/FRC account for communications. The SmartDashboard attempts to use an anonymous one.
The other thing I've seen a few times is that the MBps counter working on the default LV dashboard, but no image showing. This is an activation issue. I believe that running the Start>>National Instruments>>License Manager will allow you to license the NI Vision component so that it will actually display the image. Greg McKaskle 
|
|
#4
01-04-2013, 22:36
|
|||
|
|||
|
Re: Programming Axis Camera 206
Did you install the support files for the dashboard? The installer is on the LV DVD that was released at kickoff. If it isn't there to activate, then that would also explain it.
Greg McKaskle
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Hybrid Mode
