|
|
|
 As goes with all of my advice on CD, try it yourself and make up your own mind. I'm just suggesting things based on experience. See what works for your team. Follow my suggestions to the letter, mix and match them, or even throw them completely out the window. It's all about you and your team. - DampRobot [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Drivetrain help
I need some help...wondering if the following will work.
Attach a drill motor to each of the rear wheels. Attach a chippewa motor to each of the front wheels. Gear the chippewa motor down to the same free speed as the drill motor in low (300 rpm). We would leave the drill motor in low when we want torque and shift it to high when we want speed. If we ran all 4 motors at full speed (with the drill motors in high (free speed of 1,000 rpm)), would the wheels attached to the chippewa motors drag or roll freely? Is there anything we could do to help this situation? Please reply if you can help, Matt Cuttitta Team #894 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| drivetrain mouts and gears | Andrew Dahl | Technical Discussion | 3 | 01-22-2003 01:21 PM |
| My team is toying with drivetrain ideas .. . | Frank(Aflak) | Technical Discussion | 12 | 01-10-2003 09:52 PM |
| Best source for gears? Smallparts? drivetrain advice wanted! | Frank(Aflak) | Technical Discussion | 11 | 01-10-2003 05:22 PM |
| What motors power your drivetrain? | Khalicl13 | Motors | 35 | 12-03-2002 04:33 PM |
| Computer modeling of drivetrain and devices | archiver | 2000 | 1 | 06-23-2002 11:02 PM |
Threaded Mode