[FTC]: Using Autodesk Inventor for FTC models

In FIRST you have the right to remain silent, anything you say can and will be held against you and your associates in the court of public opinion. - Koko Ed [more]

		Chief Delphi > Other > FIRST Tech Challenge
[FTC]: Using Autodesk Inventor for FTC models

Thread Tools

Rating:

Display Modes

04-04-2013, 10:24

smcmahon

The Architect

AKA: Sean McMahon

FRC #2656 (QUASICS)

Team Role: Coach

Join Date: Jan 2008

Rookie Year: 2008

Location: Pittsburgh, PA

Posts: 197

smcmahon is an unknown quantity at this point

Re: [FTC]: Using Autodesk Inventor for FTC models

Funny, I was just over at 3D Content Central before I came back to check on this. Searching "FTC" there will get you a decent amount of stuff, as will "tetrix" as you suggested. Good stuff, thank you!

__________________
FRC 2656 | FTC 5526 | VEX 9656

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 12:47.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.