|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools |
Rating:
|
Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: pic: Independent Swerve Module
Is the wheel carrier a single piece? I know on the revolution modules the side parts bolt on to a central body which saves a lot of machining time and cost. Otherwise brilliant design and an excellent render.
|
|
#2
|
||||
|
||||
|
Re: pic: Independent Swerve Module
You can make the wheel carrier out of purchased square tube to eliminate the need to bolt it together.
|
|
#3
|
||||
|
||||
|
Re: pic: Independent Swerve Module
I only see one motor, which appears to be driving the wheel. How are you rotating the module?
|
|
#4
|
||||
|
||||
|
Re: pic: Independent Swerve Module
There is a window motor directly above the wheel, in between the plates, that would be responsible for rotation.
|
|
#5
|
|||
|
|||
|
Re: pic: Independent Swerve Module
that is a great looking render too bad these were never made
Last edited by lukedude43 : 11-04-2013 at 02:47. |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|