Quote:
Originally Posted by Oblarg
1) Hex shafts which are turned down to fit into circular bearings on their ends. AndyMark sells a couple of these for use in their gearboxes, but they're made of steel and they're too short - does anyone know if any supplier sells these in either 6061 or 7075, or would we need to just buy a hex shaft and lathe it ourselves?
|
Sounds like you're just going to have to buy a .5" hex shaft and turn down the edge yourself. Shouldn't be too difficult if you do have a lathe.
Do you mean...? If so, it's illegal under 
Hybrid Mode
