|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||||
|
|||||
|
This is probably a question for Innovation First. Did you calibrate the speed controllers? If so did you get a confirmation that the calibration was accepted. See http://www.innovationfirst.com/FIRST...sersManual.pdf for procedure.
I would next ask if the speed controllers react the same if the robot controller is not powered up when you apply power to the controllers. I was under the impression that the RC was supposed to disable or set to zero all PWM outputs while initializing. If the controllers are normal with no power to the RC, you might have a problem with the RC |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Threads getting too long to make sense of | Ken Leung | CD Forum Support | 22 | 05-05-2005 01:14 |
| Illuminated Switches | Josh Hambright | Electrical | 4 | 30-01-2003 13:55 |
| Please help make the Nationals in Houston AWESOME ... You be the Tournament Director | Natchez | General Forum | 42 | 13-12-2002 18:50 |
| LED colors | archiver | 2001 | 1 | 24-06-2002 00:04 |
| Rookie Programmer has question about the default code | DanL | Programming | 3 | 26-01-2002 19:59 |