|
|
|
 Think of the build season as kiddie bowling. Mentors should be the bumpers and your mom who lines you up and gives you advice. - Joe Matt [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Think of the build season as kiddie bowling. Mentors should be the bumpers and your mom who lines you up and gives you advice. - Joe Matt [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
SMC valve leak?
When we recieved the smc double solonoid valve and assembled them, there was a leak out of the ports when the valves are in the off position. Also, we recieved two gaskets although the SMC website only specifies that there is one gasket. Is this a problem with the gaskets, something we recieved wrong, or our assmebly?
thanks, team 1155 |
|
#2
02-02-2003, 01:04
|
||||
|
||||
|
This has been discussed. But, for reference, only use the rubber pad that has guide holde for the screws and the leak goes away. Well, it did for us.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SMC Double Action Valve. | Josh Hambright | Pneumatics | 2 | 14-02-2003 10:24 |
| SMC Double Solenoid Valve Assembly | Dave Kempskie | Pneumatics | 0 | 29-01-2003 13:34 |
| Will trade for double solenoid valve | archiver | 2001 | 2 | 24-06-2002 00:33 |
| Dismantle Solenoid valve? | archiver | 2001 | 2 | 23-06-2002 23:34 |
| Single Solenoid Valve SMC | Chubtoad | Technical Discussion | 3 | 20-01-2002 15:16 |
Linear Mode
