Simulation of Pneumatics in Autodesk Inventor 2013

Im ready for anything. - davidthefat [more]

		Chief Delphi > Technical > Pneumatics
Simulation of Pneumatics in Autodesk Inventor 2013

Thread Tools

Rate Thread

Display Modes

22-05-2013, 15:06

yajzse

Registered User

no team

Join Date: May 2013

Location: Philippines

Posts: 5

yajzse is an unknown quantity at this point

Re: Simulation of Pneumatics in Autodesk Inventor 2013

the flexible pneumatic that I was saying is a flexible bending joint..
the bending of the flexible pneumatic will depend on the air pressure that will enter its air cavity.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 16:30.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.