|
|
|
 Nats allows an exchange of a vast multitude of ideas from everywhere. Not only in robot design, but accents, tool storage, pit design, team spirt, clothing, many things.
- Wetzel [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
#3
23-06-2013, 17:19
|
||||
|
||||
|
Re: Chain Tensioning
In addition to what DonRotolo said, the guideline you're referring to doesn't work unless the two sprockets have the same number of teeth, like in a wheel to wheel connection. Are you looking at a chain that goes from a smaller sprocket on a gearbox to a larger sprocket on a wheel? If so, you can still use your center distance calculator to figure out a suitable center distance that gives a chain length that is a multiple of 0.750".
Last edited by Nemo : 23-06-2013 at 17:22. Reason: worded incorrectly 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode