Retaining Ring Groove Tool

Place a corner of it on the end of a table, clamp down the other side, and have a good whack at it with a hammer (hard). If it didn't break, it was polycarbonate. - vivek16 [more]

		Chief Delphi > Technical > Technical Discussion
Retaining Ring Groove Tool

Thread Tools

Rating:

Display Modes

27-06-2013, 11:52

Cory

Registered User

AKA: Cory McBride

FRC #0254 (The Cheesy Poofs)

Team Role: Engineer

Join Date: May 2002

Rookie Year: 2001

Location: Redwood City, CA

Posts: 6,807

Re: Retaining Ring Groove Tool

I view grinding tools as a stopgap measure if you absolutely need to get it done now and you can't go buy the tool you need.

It's so much nicer working with inserted grooving tools, especially in small sizes.

__________________
2001-2004: Team 100
2006-Present: Team 254

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

All times are GMT -5. The time now is 12:47.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.