Arduino + Ethernet Shield Help

[jwallace15]

Originally Posted by BornaE

Back to the code, what do you get printed on the serial port when you press the buttons?

Allow me to test (it did say something I just can't remember)

...

Alright testing now.

Accessed the webpage, serial printed...

 HTTP
favicon.i,,

Pressing "On"

Prints the same. No LED.

Pressing "Off"

Same thing. And no LED.

When I press the buttons, the TX and RX leds blink on both the ethernet shield and the R3, and an LED I connected to pin 13 (it is not in the code though, it's just there to show me if the Arduino LED blinks) gets a little bit brighter when the TX and RX leds blink.