|
|
|
 The term normal is relative to CADer side of me. When compared to the rest of society, there is no normal side of me. - Pault [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| The term normal is relative to CADer side of me. When compared to the rest of society, there is no normal side of me. - Pault [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#32
07-08-2013, 21:28
|
|||
|
|||
|
Re: Team 67's incredible shooter
I just stumbled across this very informative thread. Adam, have you guys experienced any problems with side loading of the 550 motors? I'm looking to set up some Banebots RS-775 motors in a similar belt drive configuration with the pulley cantilevered on the shaft, but had some doubts about how the motor's internal bearings would hold up over time. (The 775 motor only has a 7.6 mm long shaft, which is another problem in itself...)
Cheers, Phil Last edited by whophil : 08-08-2013 at 00:44. Reason: added units for shaft length |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Threaded Mode